立正检测销售李经理 详情咨询微信michaeljackson8888同行勿扰
2.30 模具
程序
遵循MIL-STD-810G方法508.6第4.4节。
标准
对于视觉上暴露在客户面前的材料。
o 材料上不应该有真菌生长。
对于不在客户视线范围内的材料。
o 可以允许真菌生长,但该装置应按原定计划完整地运行。
报告和行动
测试后的单元图像必须包括在报告中。任何性能下降或失效的情况
性能上的任何退化或故障,都应报告其根本原因分析。
报告应根据项目文件控制程序QOS30006以Agile形式发布。2.30 Mold
Procedure
Follow MIL‐STD‐810G Method 508.6 Section 4.4
Criteria
For materials visually exposed to customers:
o No fungal growth should be present on materials.
For materials not visually exposed to customers:
o Fungal growth may be allowed but the unit shall function in its entirety as intended.
Reports and Action
Images of the unit after the test must be included in the report. Any degradation or failure in
performance should be reported with root‐cause analysis.
Report shall be released in Agile per the Project Documentation Control Procedure QOS30006.